Up and at em by 7:30.. fans on. So I put together to leg set for chair 2 front leg to side leg with screws. also predrilled the holes for the arm brackets and the holes for the front board. I did not mount the board in place or would have run out of room today. But working on the two back frame pieces gave me lots of space. So you can see the slat spacing and top cross piece and bottom larger piece. The mid piece I learned to work last as it mounts to the back of the arms so fitting it later and screw holes is a custom fit.It has a bevel cut to hold the back. Also gave me the chance to look over the slats as this is a show off part and sand off errors. In the plans they want you to do this one by one with the chair upriight, and i found that a bit tedious and not see the big picture of the curve. Also cut that curve is easier not in the air. So with the bench clean. AHHH. Then a pic of parts done today. 2 back frames, leg set for chair 2, and the first chair outdoors——I even gave it a test sitting, very good. The chairs will be a white paint to hold up in the sunshine under my back patio. Not in the sunshine, so i am working on long life here.