And…a glue up?
Tails…more of the same…lay them out..
Bandsaw to cut on the waste side of the lines..and a few extra cuts, to help the waste escape..
Chop a few times from the Show face, first..
Then flip over, and finish the chopping..
Test fit…showed an issue..
Something keeping things from closing up?
Clean up with a few whacks of a chisel, remove the crumbs..
That’s better….repeat for the other end..
Next..set up a plough plane..
For a 1/4” x 1/4” groove, a 1/4” in from the bottom edge…
All 4 sides get a groove…
Just had to adjust the jig for each side….then a dry fit of a couple sides, to help mark out a plywood bottom panel…
Bandsaw left a few waves in the cut…Junior Jack to level them out..a full dry fit?
Then some glue, a few cauls, and a forest of clamps…
And let this sit a day…Busy weekend?
You might say that….these shavings have a “Krunch” to them…
Monday’s plan?
Will involve this little tool…
Stay tuned..