Resaw #3 results..
.
Tablesaw seems to have a wider kerf than the D8….not a biggie..Resaw #4 was about the same….just an inch less to saw through….
The next day ( Saturday) Resaw #5…
Was for that “knotty” end board…
I figure to cut the best out of these 2…
To make the back and 2 sides of the drawer….
Next, reset the tablesaw…and rip things for width….more like 4” ..
Then a plane can be used…
Edges jointed…faces smoothed flat…
To get rid of the rip saw’s saw marks. The panel for the front of the box, needs split..
Part for the front of the top compartment..
And the lower half for the front of the drawer…Done right, the grain will match up between the two pieces
After about 90 minutes in the shop, was soaked through, cramps were trying to start….time to sweep up this pile, and head upstairs…..have an Ice Cold Tonic & Gin awaiting me…
Sunday? Layout work for a compartment bottom panel, and start on dovetails…
Stay tuned